Outdoor Remote Wall Wash Lights

Looking for an outdoor fixture that is the equivalent to the Color Kinetics Color Cast fixture? There is no need for expensive power supplies or controllers with this fixture. The led light bar is a self contained fixture that is rated for indoor and outdoor use. Each fixture has a power plug that you plug right into the wall that is 120 volts and only uses 30 watts of power. The beam angle on this light is 40 degrees and it will wash walls up to 15 feet. The fixture has super bright 10 millimeter led light bulbs and the fixture has the capability of making 16 million different colors. The fixtures dimensions are 39 inches by 3 inches by 3 inches. Each fixture has a DMX in and out ports so you will have the ability to daisy chain the lights together and individually dmx address them through the IR remote control which is sold separately. One remote control can power an infinite amount of lights. Remote controls are sold separately and can be found in our wall washing light category. Using the remote control you can choose from seven static colors of red, green, blue, cyan, purple, yellow, purple and white. Also, there is a color fade, color wash, and color change mode as well. You can even speed up or slow down the rate of the program and adjust the light intensity as well.

The Led smartbar 1-watt RGBW 36 inch comes with 48 1-watt Led's (12 red, 12 blue, 12 green, and 12 white). The smartbar 1-watt RGBW has 5 channels (static color, color change, internal programs, master/slave and strobe). The unit is controlled by IR signal (which requires an IR remote to address the fixture sold separately) or DMX signal. The unit has a 30 degree beam angle, consumes 80-watts of power, and plugs into a standard electrical outlet. The dimensions are length 36 inches, width 3.5 inches, and height 9 inches.

Bigger, brighter and better. Introducing the 3 watt outdoor 40 inch wall washing light. A perfect addition for people who need more light at a reasonable cost. There is no need for expensive power supplies or controllers with this fixture. The led light bar is a self contained fixture that is rated for indoor and outdoor use. Each fixture has a power plug that you plug right into the wall that is 120 volts and only uses 70 watts of power. The beam angle on this light is 40 degrees and it will wash walls up to 50 feet. The fixture has super bright 3 watt led light bulbs and the fixture has the capability of making 16 million different colors. The fixtures dimensions are 39 inches by 3 inches by 3 inches. Each fixture has a DMX in and out ports so you will have the ability to daisy chain the lights together and individually dmx address them through the IR remote control which is sold separately. One remote control can power an infinite amount of lights. Remote controls are sold separately and can be found in our wall washing light category. Using the remote control you can choose from seven static colors of red, green, blue, cyan, purple, yellow, purple and white. Also, there is a color fade, color wash, and color change mode as well. You can even speed up or slow down the rate of the program and adjust the light intensity as well.

The 3-watt par 64 RGB comes with 12 3-watt RGB Led's (4 red, 4 blue, and 4 green) and is IP44 rated. The 3-watt par 64 RGB is 5 channel (red, green, blue, dimmer, and strobe). The unit is controlled by IR signal (which requires an IR remote to address the fixture sold separately) or DMX signal cable and comes with built in programs, auto run, DMX mode, master and slave mode, or dimming mode. The unit has a 30 degree beam angle, consumes 40-watts of power, and plugs into a standard electrical outlet. outdoor 3-watt Par 64 RGB data sheet

Bigger, brighter and better. Introducing the 3 watt outdoor led wall washer 3 watt. These are some of the brightest wall washing fixtures available on the market at a reasonable cost. These units are fully DMX capable and we also have an IR remote control as well for these fixtures so residential customers can have easy control over them without expensive DMX controllers. Each unit contains 24 each 3 watt led light bulbs (8 red, 8 blue, 8 green) and the bulb layout has been improved for better color saturation. These units are ready to go right out of the box and have a standard Edison plug so there is no electrical wiring involved. They are listed for indoor and outdoor use. The fixtures are 120 volt and the maximum power consumption is 40 watts. The light has a beam angle of 20 degrees and is IP44 rated. Dimensions of the light are 8 inches by 8 inches by 12 inches and they have a cast aluminum housing. One remote control can power an infinite amount of lights. Remote controls are sold separately and can be found in our wall washing light category. Using the remote control you can choose from seven static colors of red, green, blue, cyan, purple, yellow, purple and white. Also, there is a color fade, color wash, and color change mode as well. You can even speed up or slow down the rate of the program as well. If you would like to use these lights on a DMX controller, they have they use the standard 3 pin DMX cables and each light has an in and out. Each light will take 4 channels of DMX. (Red, Green, Blue, Strobe)

The smart bar 39 white uses 16 white and 8 amber 3 watt led light bulbs. With the IR remote control you can adjust the white light color temperature between 2800k and 6000k. This fixture can be fully DMX addressed as well for stage lighting applications such as back drop washing. The fixtures dimensions are 40 inches long by 3 inches high and 3 inches wide. The light will produce an nice even wash of 40 inches wide by 50-100 feet long in the dark. The fixtures also have the ability to master and slave with the remote and there is dimming capability as well with the IR Remote.

The signal extensions are for our outdoor rated wall washing lights and our outdoor par 64 lights. You will need this cable for connecting two or more lights together in DMX mode.

This DMX adapter is needed if you would like to use our outdoor led lights in DMX mode. Since outdoor rated DMX cable has a different connection for outdoor use, you will need this adapter to adapt from outdoor DMX to standard indoor 3 pin XLR so you can connect the lights to your controller. The adapter cord is 3 feet in length.